Eec iv pinout4/3/2023 ![]() ![]() ID'ing the wires on the car ought to be pretty simple since I can follow them all the way into the car. I'll pull the vic in the garage tomorrow and start swapping, I hope to set some sort of speed record in getting this running. Swapping to the 94-95 MAF Mustang EEC from the '87 SD EEC will be simple since the extra wires needed already exist in the Lincoln harness. I'm depinning them and not going to lose any sleep over it. ![]() I removed the 3 with the plug for the servo leaving only the aforementioned 3 wires. Only pins 28, 34, and 39 are not positively identified, but in the GM 5.0HO swap thread an EVTM page indicated that there were 6 wires on the EEC all for the cruise control. Pins 8 and 44 are data bus wires that don't exist on the lopo SD and EFI SD/88-93MAF cars. Funny story here, this SD LTC Harness doesn't match the pinouts for the SD CV/GM harnesses listed on the above website, but according to a pinout provided on CVN, it matches wire colors and all the MAF (CA?) LTC minus the fact that there was no MAF installed on the vehicle. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |